Standard Swedish standard · SS-EN ISO 5164:2014

Petroleum products - Determination of knock characteristics of motor fuels - Research method (ISO 5164:2014)

Status: Valid

Buy this standard

Standard Swedish standard · SS-EN ISO 5164:2014

Petroleum products - Determination of knock characteristics of motor fuels - Research method (ISO 5164:2014)
Subscribe on standards - Read more Dölj
Price: 1 152 SEK
standard ikon pdf

PDF

Price: 1 152 SEK
standard ikon

Paper

Price: 1 843,20 SEK
standard ikon pdf + standard ikon

PDF + paper

Show more Show less
Preview this standard
Scope
This International Standard establishes the rating of liquid spark-ignition engine fuel in terms of an arbitrary scale of octane numbers using a standard single-cylinder, four-stroke cycle, variable compression ratio, carburetted, CFR engine operated at constant speed. Research octane number (RON) provides a measure of the knock characteristics of motor fuels in automotive engines under mild conditions of operation.This International Standard is applicable for the entire scale range from 0 RON to 120 RON, but the working range is 40 RON to 120 RON. Typical motor fuel testing is in the range of 88 RON to 101 RON.This International Standard is applicable for oxygenate-containing fuels containing up to 4,0 % (m/m) oxygen and for gasoline containing up to 25 %(V/V) ethanol.NOTE 1 Although 25 % (V/V) of ethanol corresponds to approximately 9 % (m/m) oxygen, full applicability of this test method for that oxygen range has only been checked for gasoline type of fuels.NOTE 2 Work is under way to check the possibility to use the method up to and including 85 %(V/V) ethanol.NOTE 3 This International Standard specifies operating conditions in SI units but engine measurements may be specified in inch-pound units because these were the units used in the manufacture of the equipment, and thus some references in this International Standard include these units in parenthesis.NOTE 4 For the purposes of this standard, the terms “% (m/m)” and “% (V/V)” are used to represent the mass fraction, µ, and the volume fraction, f, of a material respectively.

Subjects

Liquid fuels (75.160.20)


Buy this standard

Standard Swedish standard · SS-EN ISO 5164:2014

Petroleum products - Determination of knock characteristics of motor fuels - Research method (ISO 5164:2014)
Subscribe on standards - Read more Dölj
Price: 1 152 SEK
standard ikon pdf

PDF

Price: 1 152 SEK
standard ikon

Paper

Price: 1 843,20 SEK
standard ikon pdf + standard ikon

PDF + paper

Show more Show less

Product information

Language: English

Written by: Svenska institutet för standarder

International title:

Article no: STD-102125

Edition: 2

Approved: 6/8/2014

No of pages: 40

Replaces: SS-EN ISO 5164:2005